Hardware
We have been asked many times
about hardware requirements for CAD. We know in these economic times this
is easier said than done but don’t be guided purely by the dollar especially
for a computer to run CAD in a commercial situation. The old saying still
applies, “buy cheap and you will get cheap”. We’ve seen many situations
where Cad seems to have found the weakest point and Murphy’s Law dictates
this will happen 4.00 hrs before the job is due out. We build purpose built
CAD machines specifically for your requirements. These are fully guaranteed.
Cad software is resource hungry
and very demanding on hardware. To achieve the ultimate out of a computer
required for Cad, the computer is best built by people who understand the
requirements of Computer Aided Design software. McD Cad Consultancy provides
this service, which is a little more expensive than the computer you buy
off the shelf but these computers are designed and built to run the Cad
software properly and to the clients brief.
Because of the local nature
of the business clients have the advantage of prompt backup service. A
large proportion of the clients that the company works with are in business
critical situations where breakdowns or down time mean loss of income,
which in today’s market is unacceptable. In the unlikely event of hardware
or software failure, this in most cases can be remedied on the same day
or at least the following day. The business carries ample stocks of hardware
to eliminate wait time for the client.
|
CAD
Systems
& Support
|
